ExamBoosts NACE-CIP2-001 Exam Questions Real NACE-CIP2-001 Practice Dumps [Q26-Q50]

NEW QUESTION 26
You are the new NACE Level 2 Inspector on a job which had been very problematic. The previous Inspector was fired duo to personality conflicts with the Contractor’s supervisor. Upon arriving onsite the Contractor’s supervisor advises you in no uncertain terms that you will be the next to go, unless you cooperate with him.
Your FIRST preferred course of action is to:

NEW QUESTION 27
The primary purpose of Fireproofing coatings are to provide:

NEW QUESTION 28
When performing an adhesion test in accordance with ASTM D 3359 where the Dry Film Thickness is approximately 10 mils, the Inspector should use:

NEW QUESTION 29
Surface preparation of concrete is performed using:

NEW QUESTION 30
Ideally, documentation requirements should be defined:

NEW QUESTION 31
You are the NACE Level 2 inspector reviewing the documentation from a NACE Level 1 you notice significant documentation errors.
Your FIRST preferred course of action is to:

NEW QUESTION 32
When working with someone who is very concerned about Stability and maintaining adherence to the status-quo, the Inspector should try to:

NEW QUESTION 33
As a NACE Level 2 Inspector on a field job; prior to submission your documentation should always reviewed and approved by:

NEW QUESTION 34
When NACE/SSPC WJ 1 is referenced; what type of equipment would the Inspector expect to see on the job:

NEW QUESTION 35
You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course of action should to:

NEW QUESTION 36
The cost of qualified Coating Inspection is normally offset by:

NEW QUESTION 37
In powder coatings, when the particles of powder begin to flow but are not fully liquid, they are in what stage?

NEW QUESTION 38
The Inspectors’ goal at the Pre-Job Conference is to:

NEW QUESTION 39
Which product, is used in conjunction with other coatings such as FBE when the lines run through wetlands or a body of water?

NEW QUESTION 40
Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.

NEW QUESTION 41
When performing a hardness test on a coating which has elastic properties the inspector is likely to likely to observe:

NEW QUESTION 42
When completing the Final Inspection report the Inspector should write the report using:

NEW QUESTION 43
Corrosion is the reverse process of

NEW QUESTION 44
Inspection and Test plans are developed by referencing:

NEW QUESTION 45
When observing fabrication defects the NACE Inspector should:

NEW QUESTION 46
The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

NEW QUESTION 47
NACE International Standards are developed by:

NEW QUESTION 48
Which product, when closely inspected has a green or red layer of fusion bonded epoxy (FBE) that is visible directly on the steel?

NEW QUESTION 49
Non-Conformance Reports are designed to:

NEW QUESTION 50
From a corrosion perspective, the main difference between Ferrous and Non-Ferrous Metals is: