Free Aug-2023 UPDATED EMC DEA-5TT2 Certification Exam Dumps is Online [Q34-Q54]

NEW QUESTION 34
Which type of domains are connected by a Layer 2 switch?

NEW QUESTION 35
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?

NEW QUESTION 36
What are Network Address Translation (NAT) inside global addresses?

NEW QUESTION 37
Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

NEW QUESTION 38
In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?

NEW QUESTION 39
Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?

NEW QUESTION 40
Which IP address is in the Class B range?

NEW QUESTION 41
A network administrator wants to use a subnet that will only have two host addresses. Which subnet mask meets this requirement?

NEW QUESTION 42
Which IPv4 address is in the same network as the IP address 182.15.24.40/23 and assignable to a host device?

NEW QUESTION 43
On which OSI layers do standard ACL filters operate?

NEW QUESTION 44
When configuring a switch, which CLI mode only supports limited show commands?

NEW QUESTION 45
What accurately describes the Network Time Protocol (NTP)?

NEW QUESTION 46
You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.
If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?

NEW QUESTION 47
Which BASE-T Ethernet standard specifies a CAT6 cable type?

NEW QUESTION 48
How is a switch different from a hub?

NEW QUESTION 49
A network administrator is troubleshooting an OSPF routing issue. There are two paths to a destination network from one switch. In addition, one path is comprised of four 1 Gb links. The other path is comprised of two 1 Gb and two 100 Mb links. The administrator ran several trace routes and notices that the packets are swapping back and forth between the two paths.
Which corrective action must be taken on the switch infrastructure to correct this issue?

NEW QUESTION 50
Which port type does a Dell EMC Networking N-Series switch have for its console connection?

NEW QUESTION 51
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

NEW QUESTION 52
Which Border Gateway Protocol (BGP) version supports IPv6?

NEW QUESTION 53
A network administrator has a stack of four Dell EMC Networking S4800 Series switches. Each stack unit is configured with a different priority. Which switch will be elected as the management device?

NEW QUESTION 54
What accurately describes the comparison between stacking and VLT?