2023 Valid HPE2-W09 FREE EXAM DUMPS QUESTIONS & ANSWERS [Q77-Q94]

Q77. Two ArubaOS-CX switches ate part of a Virtual Switching Extension (V5X) fabric. Is this a guideline for configuring the switches’ link-up delay settings?
Solution: Set the link-up delay timer based on the number of MAC forwarding, ARP, and routing table entries.

Q78. Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: You want to prevent any possibility of a split brain situation from occurring if the keepalive link fails some time after the ISL.

Q79. Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) solution?
Solution: Create two ERPS instances for the ring and assign different VLANs and different ring protection links (RPL) to each instance.

Q80. Switch-1 and Switch-2 are AruDaOS-CX switches, which are part of a Virtual Switching Extension (VSX) fabric. Switch-2 is the primary member. Switch-2 experiences a power failure while Switch-1 remains up. Switch-2’s power recovers, and Switch-2 reboots.
Is this one of the things that happens when Switch-2 finishes booting?
Solution: Switch-2 wails a period called the link-up delay before it enables Switched Virtual Interfaces (SVls) on its VSX LAGs.

Q81. You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The guard interval is set in units of seconds and is used to prevent frequent topology changes due to a link going up and down.

Q82. Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISI between Switch-1 and Swltch-2. enable active forwarding on LAG 100 on both Switch-1 and Switch-2.

Q83. Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Combine multiple links between two data centers into link aggregations (but not multi-chassis ones).

Q84. Refer to the exhibit.

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add a route with this command: ip route 10.1.20.0/24 vlan20 vrf A

Q85. Is this a use case for disabling split-recovery mode on ArubaOS-CX switches in a Virtual Switching Extension (VSX) fabric?
Solution: You are not concerned about split Drain Issues in your environment, so you want the secondary member to keep its links up if the ISL falls.

Q86. Does this correctly describe routing information advertised by a VXLAN Tunnel Endpomt (VTEP) that uses EVPN?
Solution: MAC/IP advertisement routes advertise the MAC addresses that can be reached through the VTEP.

Q87. Is this something that NetEdit 2.0 does after it discovers a switch?
Solution: It enables the switch REST API Interface, if disabled.

Q88. Is this a guideline for establishing a Virtual Switching Extension (VSX) Inter-Switch Link (ISL) between two ArubaOS-CX switches?
Solution: Use the same speed on every link In the ISL.

Q89. Is this a guideline for establishing a Virtual Switching Extension (VSX) Inter-Switch Link (ISL) between two ArubaOS-CX switches?
Solution: Use a link aggregation with multiple 40GbE links or multiple 100GbE links.

Q90. You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.
Is this a rule for the setup?
Solution: You cannot leak multicast routes.

Q91. Refer to the exhibit.

which shows the topology tot an Ethernet Ring Protection Switching (ERPS) solution.
Is this a valid design for the control and protected VLANs on the VSX fabric 1 switches?
Solution: Ring 1, instance 1:
control VLAN: 1000protected VLANs: 51-135 Ring l,Instance2:
control VLAN: 1001 protected VLANs: 136-220 Ring 2, Instance 1: control VLAN: 1000 protected VLANs: 181 -200 Ring 2, Instance 2: control VLAN: 1003 protected VLANs: 201 -220

Q92. Is this a way that a data center technology can help meet requirements for multi-tenancy?
Solution: Virtual Routing and Forwarding (VRF) enables multiple isolated Layer 3 domains, each with its own routing table, to share a physical network.

Q93. You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The wait to restore timer (WTR) Is set in units of minutes; you can set it to prevent frequent topology changes due to a link going up and down.

Q94. Is this correct positioning of AtubaOS-CX switches in the data center?
Solution: A data center will use a leaf-spine topology and requires 64 leaf switches. Aruba CX 8325 switches can be a good choice for both the leaf and spine switches.