300-620 Certification – Valid Exam Dumps Questions Study Guide! (Updated 135 Questions) [Q60-Q76]

NO.60 When creating a subnet within a bridge domain, which configuration option is used to specify the network visibility of the subnet?

NO.61 Which type of policy configures the suppression of faults that are generated from a port being down?

NO.62 An ACI engineer is implementing a Layer 3 out inside the Cisco ACI fabric that must meet these requirements:
The data center core switch must be connected to one of the leaf switches with a single 1G link.
The routes must be exchanged using a link-state routing protocol that supports hierarchical network design.
The data center core switch interface must be using 802.1Q tagging, and each vlan will be configured with a dedicated IP address.
Which set of steps accomplishes these goals?

NO.63 An engineer is implementing a Cisco ACI data center network that includes Cisco Nexus 2000 Series 10G fabric extenders. Which physical topology is supported?
A)

B)

C)

D)

NO.64 An engineer needs to deploy a leaf access port policy group in ACI Fabric to support the following requirements:
* Control the amount of application data flowing into the system
* Allow the newly connected device to auto-negotiate link speed with the leaf switch Which two ACI policies must be configured to achieve these requirements? (Choose two.)

NO.65 An engineer is implementing a Cisco ACI data center network that includes Cisco Nexus 2000 Series 10G fabric extenders. Which physical topology is supported?
A)

B)

C)

D)

NO.66 Which protocol does ACI use to securely sane the configuration in a remote location?

NO.67 Which table holds IP address, MAC address and VXLAN/VLAN information on a Cisco ACI leaf?

NO.68 A situation causes a fault to be raised on the APIC. The ACI administrator does not want that fault to be raised because it is not directly relevant to the environment. Which action should the administrator take to prevent the fault from appearing?

NO.69 Which setting prevents the learning of Endpoint IP addresses whose subnet does not match the bridge domain subnet?

NO.70 When creating a subnet within a bridge domain, which configuration option is used to specify the network visibility of the subnet?

NO.71 How is an EPG extended outside of the ACI fabric?

NO.72 Which type of profile needs to be created to deploy an access port policy group?

NO.73 Refer to the exhibit.

An engineer is implementing Cisco ACI – VMware vCenter integration for a blade server that lacks support of bonding. Which port channel mode results in “route based on originating virtual port” on the VMware VDS?

NO.74 All workloads in VLAN 1001 have been migrated into EPG-1001. The requirement is to move the gateway address for VLAN 1001 from the core outside the Cisco ACI fabric into the Cisco ACI fabric. The endpoints in EPG-1001 must route traffic to endpoints in other EPGs and minimize flooded traffic in the fabric. Which configuration set is needed on the bridge domain to meet these requirements?

NO.75 An engineer configures a Multi-Pod system with the default getaway residing outside of the ACI fabric for a bridge domain. Which setting should be configured to support this requirement?

NO.76 An engineer is implementing a connection that represents an external bridged network. Which two configurations are used? (Choose two.)