Get Special Discount Offer of H31-341-ENU Certification Exam Sample Questions and Answers [Q102-Q119]

ExamBoosts August 7, 2022 H31-341-ENU > Huawei 0

Rate this post

Get Special Discount Offer of H31-341-ENU Certification Exam Sample Questions and Answers

New H31-341-ENU Dumps For Preparing HCIP Transmission Certified Huawei Exam Well

QUESTION 102
Which of the following operating modes does the AT8 board support? (Multiple Choice)

Reverse 2E2M

2E2M

1E1M

Reverse 1E1M

QUESTION 103
The optical and electronic shelves of the OSN 9800 are connected through the master-slave subrack cascading mode and connected through the GE 1/2 port on the CTu board.

TRUE

FALSE

QUESTION 104
During the process of maintaining the OSN device, it is often seen that the fan runs at full speed, and the device reports the TEMP_OVER alarm. What are the common causes and treatment methods?

The dust filter is heavily dusty and affects ventilation. The dust filter needs to be cleaned.

The dust inside the fan is serious, which affects the speed. You need to remove the fan to remove it.

The power module of the board is heavily dusty, affecting heat dissipation, and needs to be removed.

The optical module has an abnormal cooling function and needs to be replaced with a light board.

QUESTION 105
Which of the following paths are not related to the business?

OCh

OSC

Client

ODUk

QUESTION 106
The maximum optical power of light-emitting OBU output is 20dBm, which is used in the C-band 80 system. How much dBm should the single-wave standard output optical power be?

+4dBm

+7dBm

-2dBm

+1dBm

QUESTION 107
Which of the following application scenarios that belong to the change configuration method? (Multiple choice)

In the upgrade and expansion, if you suspect that the new configuration is faulty, you can re-issue the original configuration to locate the configuration problem.

If you suspect that there is a problem with a slot, you can exclude it by changing the board configuration.

If you suspect that there are problems with certain channels or one of the tributary boards of the tributary board, you can change the time barrier configuration to configure the service to another channel or to another tributary board.

If you suspect that there is a problem with one VC-4, you can adjust the time barrier to another VC-4.

QUESTION 108
The following description of the Directioned scenario, which is correct? (Multiple choice)

The wavelength carrying the local service can be transmitted to fixed direction.

If the current path needs to be adjusted, you must inbound to adjust the fiber connection of the network.

Directioned scenes are applied to networks that are not ASON.

When the service needs to be adjusted, or the working path is faulty, the optical crossover can be manually configured to implement flexible scheduling of services.

QUESTION 109
The wave division system complement to chromatic dispersion mainly adopts the DCM compensation method. The following statements about DCM dispersion compensation, which is wrong?

The DCM module is more likely to cause nonlinearity than the line transmission fiber, so it is necessary to strictly control its fiber-optic power.

Improper configuration of the DCM will result in degradation of the system signal-to-noise ratio.

10G system with line fiber length less than 400km, G.652 DCI can be used to compensate G.655LEAF).

Improper configuration of the DCM will result in degradation of the receiving end performance.

QUESTION 110
Using the path method to create a Client path fails. What are the possible reasons? (Multiple choice)

FEC mode does not match at both ends of the transceiver

The channel has been used up

Physical connection lacking between boards

There is no complete OCh path

QUESTION 111
Which of the following ROADN nodes are configured correct? (Multiple choice)

WSMD9

WSD9+RMU9

WSM9+RDU9

WSIM9+WSD9

QUESTION 112
Which of the following alarms trigger optical line protection switching?

POWER_DIFF_OVER

R_LOF

R_LOS

MUT_LOS

QUESTION 113
MPLS-TP is a subset of MIPLS that removes connectionless IP-based forwarding and adds end-to-end OA functionality.

TRUE

FALSE

QUESTION 114
The user-oriented interface and the interface for the transport network of the E-Line service are
____ and _____.

UNI, UNI

UNI, NNI

NNI, UNI

NN, NNI

QUESTION 115
The steps that must be performed when configuring the Ethernet private line service carried by the PW are as follows: (Multiple Choice)

Configure QoS

Configure MPLS tunnel

Configure port DCN

Configure the UNI port

QUESTION 116
The transmission plane mainly performs functions such as optical signal transmission, configuration protection switching, and reconnection, and ensures the reliability of the transmitted optical signal. However, the switching action of the transport layer is performed under the influence of the management dry surface and the control plane.

TRUE

FALSE

QUESTION 117
On the ROADM board, you need to configure the virtual optical layer service before the optical power is commissioned. Otherwise, the ROADM limit board blocks all wavelengths by default.

TRUE

FALSE

QUESTION 118
Which of the following statements about the latency of a storage and forwarding device is false?

The last bit of the data frame enters the device and starts timing.

The first bit of the data frame enters the device and starts timing.

The first bit of the data frame appears at the output port of the device and stops timing.

Reflects the performance of network devices. Generally, it is not compared with the bit forwarding device.

QUESTION 119
When creating a Client path using the path method, if the RL0S alarm is generated on the line card, the path cannot be created.

TRUE

FALSE

Loading …