100% Updated HP HPE6-A72 Enterprise PDF Dumps [Q27-Q49]

QUESTION 27
Match the available stacking feature to the correct AOS-CX switch model. Stacking features may be used more than once.

QUESTION 28
You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.
What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

QUESTION 29
Which two types of routes can be found in the IP routing table of an Aruba AOS-CX switch? (Choose two.)

QUESTION 30
What is true about VSX? (Choose two.)

QUESTION 31
Which command can be used to find the serial number of an Aruba OS-CX switch?

QUESTION 32
What is the Link Layer Discovery Protocol?

QUESTION 33
What is the correct description of a Multi-Layer Switch?

QUESTION 34
What are two mechanisms supported on AOS-CX 6300 switches used in Multi-active Detection to determine the status of the Primary member? (Choose two.)

QUESTION 35
Refer to the exhibit

Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?

QUESTION 36
What is the process where a compute device converts logical data bits into the correct physical representation depending on the media?

QUESTION 37
Refer to the exhibit.

What change on Core-1 will result in a successful ping to 10.1.1.254 from the management interface?

QUESTION 38
You have completed a successful VSF stack between two switches.
Without manually assigning a backup switch, what is the expected output when issuing a show vsf command?

QUESTION 39
ServiceOS login: admin
SVOS> password
Enter password: ********
Confirm password: ********
The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a reboot is performed and the Service OS console is accessed as shown above.
What is the default password that is required for the admin account while under the Service OS console?

QUESTION 40
Refer to the exhibit.

What configuration is needed in order for “show LLDP configuration” to show this output?

QUESTION 41
Click on the colored box that corresponds with the line that best represents Broadcast traffic flow.

QUESTION 42
What is Deep Packet Inspection?

QUESTION 43
The following command is issued:
Switch# checkpoint rollback start
What is the result?

QUESTION 44
Which two statements are true regarding Checkpoints on Aruba switches? (Choose two.)

QUESTION 45
Refer to the exhibit.

The above scenario shows a packet from the Server destined for the Firewall. Switch-A and Switch-B are bundled as VSF stack. The LAG between the VSF stack and the firewall indicates a hash function to forward the packet on port 2/1/2.
Which statement is true regarding how Switch-A will forward the packet?

QUESTION 46
Which statement is correct regarding powering an Aruba Access Point?

QUESTION 47
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

QUESTION 48
Which two options are the Layer 2 protocols? (Choose two.)

QUESTION 49
Refer to the exhibit.

The above output is the result of issuing the command show system resource-utilization. What command should be used to enable terminal output line by line or page by page?