Go to NACE-CIP1-001 Questions – Try NACE-CIP1-001 dumps pdf [Q12-Q30]

NEW QUESTION 12
Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator’s cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his “insurance policy” for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

NEW QUESTION 13
In the event of a conflict between the project specification and the coating manufactures’ product data sheet, the Inspector’s first course of action should be too:

NEW QUESTION 14
A magnetic pull-off type gauge is a good choice when:

NEW QUESTION 15
A successful coating inspector must be able to

NEW QUESTION 16
In a non-convertible coating the role of the primary solvent is to:

NEW QUESTION 17
To be of value the Inspector’s documentation must be:

NEW QUESTION 18
An inspectors personal log book should contain:

NEW QUESTION 19
ISO ST 3 is described as:

NEW QUESTION 20
As a NACE Coating Inspector your responsibility with respect to safety is to:

NEW QUESTION 21
A single application coating film has a measured dry film thickness (DFT) between 4 and 5 mils (between 100 and 125 microns). The volume solids of the coating immediately before application were 67%, What wet film thickness (WFT) was applied?

NEW QUESTION 22
Checking is

NEW QUESTION 23
It is good practice for the NACE Inspector to have instrument calibration certificates available:

NEW QUESTION 24
ASTM Standards are applicable:

NEW QUESTION 25
NACE No. 4/SSPC-SP-7 is a joint standard for

NEW QUESTION 26
You are the NACE Inspector on a job where the Owner’s specification requites you to perform a twice daily check of blast pressure at the nozzle. It is now day 30 on the job and all of your readings have been within compliance. The Contractor complains that these checks taking up much time and in view of the compliant results they are unnecessary.
Your FIRST preferred course of action is to:

NEW QUESTION 27
Which one of the following documents is the best source for coating technical data:

NEW QUESTION 28
What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial-type magnetic pull-off Dry Film Thickness (DFT) gauge?

NEW QUESTION 29
Whenever dissimilar metals must join, the most common practice is to

NEW QUESTION 30
The initial steel condition is important to the NACE Inspector because: