Download NACE NACE-CIP1-001 Mock Test Study Material [Q49-Q70]

Q49. Whenever dissimilar metals must join, the most common practice is to

Q50. Relative humidity is

Q51. You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors.
Your FIRST preferred course of action is to:

Q52. When using a sling physchrometer a very large difference between the wet and dry bulb readings indicates:

Q53. Inspector’s daily reports are used:
Select All That Apply

Q54. Passivation can best be described as:

Q55. Owners hire NACE Inspectors’ with the expectation that:

Q56. You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

Q57. What is used to determine compressed air cleanliness?

Q58. It is good practice for the NACE Inspector to have instrument calibration certificates available:

Q59. What is the minimum spot measurement value allowed by SSPC-PA 2 in each 10 m2 (100 ft2) area?

Q60. Stripe coats are generally applied to:

Q61. Removal of surface contaminants is done by:

Q62. Good records can provide maintenance departments with detailed information about ALL of the following EXCEPT

Q63. Which is a component that supplies most of the features and functions of the material?

Q64. You are the NACE Coating Inspector on an exterior job where the contractor is not using any environmental controls, For the last several hours your reading; indicate the relative humidity is rising and the substrate temperature is dropping. The sky is clouding over and the weather forecast is for evening showers. It is now 4 PM, your readings indicate you have minimally acceptable environmental conditions, however if the current trend continues, you expect to be outside specified conditions soon. The contractor advises you he is going to mix up the next full kit to complete his for the day.
Your FIRST preformed course of action is to:

Q65. The initial steel condition is important to the NACE Inspector because:

Q66. Checking is

Q67. If a Thermoset coating is heated it will:

Q68. NACE Level 1 Inspectors have been trained to perform:

Q69. NACE No. 4/SSPC-SP-7 is a joint standard for

Q70. An inspectors personal log book should contain: