HPE2-W09 100%合格保証ダウンロードHPE製品認定試験PDF Q&A【Q47-Q62

新しい質問 47
Does this correctly describe how Network Analytics Engine (NAE) agents work?
Solution: Agents write data to the switch’s current state database.

新しい質問 48
You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The wait to restore timer (WTR) Is set in units of minutes; you can set it to prevent frequent topology changes due to a link going up and down.

新しい質問 49
You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.
Is this a rule for the setup?
Solution: You can only leak routes between up to three VRFs.

新しい質問50
Is this a way that Virtual Switching Extension (VSX) differs from Virtual Switching Framework (VSF)?
Solution: VSX permits admins to select which features to synchronize between members while VSF requires manual configuration of Identical features on each member of the VSF fabric.

新しい質問 51
Two ArubaOS-CX switches ate part of a Virtual Switching Extension (V5X) fabric. Is this a guideline for configuring the switches’ link-up delay settings?
Solution: The link-up delay timer is only required when split-recovery is disabled.

新しい質問 52
Is this a difference between a typical data center network’s requirements and a typical campus network’s requirements?
Solution: Data center networks are typically less oversubscribed than campus networks.

新しい質問 53
Is this statement about ARP and ND Suppression true?
Solution: ARP-Suppression and ND-Suppression must be enabled together.

新しい質問 54
Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) solution?
Solution: Create two ERPS instances for the ring and assign different VLANs and different ring protection links (RPL) to each instance.

新しい質問 55
Is this statement about ARP and ND Suppression true?
Solution: Both ARP-Suppression and ND-Suppression are disabled by default.

新しい質問56
Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: ensures a minimum bandwidth guarantee between two endpoints traffic with various 802.1 p values.

新しい質問 57
展示を参照。

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add a route with this command: ip route 10.1.20.0/24 vlan20 vrf A

新しい質問 58
You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: omit the device-specific settings from the configuration plan and include them in command scripts instead.

新しい質問 59
A data center has a three-tier topology with ArubaOS-CX switches at each layer, is this a use case for implementing Virtual Switching Extension (VSX) at the core?
Solution: The customer wants to deploy a single control plane for the core fabric.

新しい質問 60
展示を参照。

You want to enable devices in VRF B and VRF C to reach shared resources in VRFA.
is this a valid strategy for meeting this goal?
Solution: Create a separate OSPF process for each VRF on Switch-1. Then redistribute each process into the other VRFs’ processes.

新しい質問 61
Is this something that NetEdit 2.0 does after it discovers a switch?
Solution: It enables SNMP on the switch, if disabled.

新しい質問 62
Is this a rule for configuring schedule profiles on an ArubaOS-CX switch?
Solution: With the exception of a single strict priority queue, all queues must use the same scheduling algorithm.